Correct Usage; Preparation - Toshiba Carrier MCY-MAP0367HS-UL Manuel Du Propriétaire

4

Correct usage

When the air conditioner is used for the first time or the setting is changed, follow the steps below. The settings are
saved in memory and are displayed anytime the unit is turned on by pushing the
 Preparation
When the circuit breaker is turned on, the partition lines are displayed on the remote control.
* After the circuit breaker is turned on, the remote control does not accept any commands for approximately
1 minute, this is not a failure.
REQUIREMENT
When the air conditioner is turned on after it has not been used for a long period, turn on the circuit breaker at least
12 hours prior to starting the air conditioner.
TEMP. ON / OFF
4
TIMER SET FAN MODE
TIME SAVE VENT
FILTER
RESET TEST SET CL SWING/FIX UNIT LOUVER
Start
1
Push button.
The operation lamp illuminates, and the operation
starts.
2
Select an operation mode with the "
button.
The operation mode changes each time the button
is pushed in the following order.
Heat Dry Cool
13-EN
button.
3
Select fan speed with "
The fan speed changes each time the button is
pushed in the following order.
Auto High Med.
1
• When the fan is in " Auto", fan speed is
3
adjusted based on the difference between the
2
set point and room temperature.
• In the heating operation, if the room temperature
is not heated sufficiently with volume "
operation, select " Med." or "
operation.
• The temperature sensor detects the return air
temperature at the indoor unit, which differs
from the room temperature depending on the
installation condition.
Set point is a target of room temperature.
"
( "Auto" is not selectable in the Fan
mode.)
The fan speed selecting function is not available
for the high static ducted type.
Only "HIGH" is displayed.
4
Select the set point temperature by pushing
Fan
the "TEMP. " or "TEMP.
Stop
Push button.
The operation lamp goes off, and the operation stops.
In the Cool, Dry, or Auto (cooling) mode, the fan runs
for 10 minutes (or more) for self cleaning.
– 7 –
NOTE
Cooling
• If there is a demand for cooling, the unit will start
approximately 1 minute after mode is selected.
Heating
• If there is a demand for heating, the unit will start
approximately 3 to 5 minutes after the mode is
selected.
• After the heating operation has stopped, the fan may
continue to run for approximately 30 seconds.
• When the room temperature reaches the set
temperature and the outdoor unit stops, the indoor unit
fan runs at ultra low speed and the outdoor unit fan
runs at low speed. (For the high static ducted type, the
fan speed does not change after the temperature has
reached the set point.)
During the defrost operation, the fan stops so that cool air
is not discharged. ("
" button.
When restarting the operation after stop
• When attempting to restart the unit immediately after
it was stopped, the unit can not start for approximately
3 minutes due to the compressor's protection feature.
Low
.
Low"
High"
" buttons.
" Pre-heat is displayed.)
14-EN