Toshiba Carrier MCY-MAP0367HS-UL Manuel Du Propriétaire page 17

CAUTION
Do not start the air conditioner if the panel and air filter
removed.
Cleaning Unit Grille and Frame
To clean the grille and the frame, wipe the outside with
a soft, dry cloth. If necessary, a mild liquid detergent
can be applied and wiped off with a dry cloth.
Preparing for long Shut Down Period
1
Clean the filters and reposition them in the
unit.
2
Operate the unit in fan mode for 3 or 4 hours
to dry all the internal parts.
3
Turn the unit off and disconnect the main
power supply.
4
Turn on the circuit breaker for at least 12
hours before the unit is turned on again.
 Compact 4-way Cassette type
1
Open the air intake grille.
Slide the air intake grille buttons to detach the air
intake grille from the main ceiling panel. Lower the
grille slowly whilst holding.
Air intake grille
Button
2
Take out the air filter.
Push the air filter extrusion away from the grille
and remove.
Strap to prevent
falling
Air filter
31-EN
3
Cleaning with water or vacuum cleaner
• If dirt is heavy, clean the air filter using tepid
water with a neutral detergent or just water.
• After cleaning with water, dry the air filter
sufficiently in a shaded place.
4
Mount the air filter.
5
Close the air intake grille.
Close the air intake grille, slide the button to
secure into the ceiling panel.
Air intake grille
Button
6
Push the "FILTER RESET " button.
display disappears.
◆ Cleaning of air discharge louver
The air discharge louver can be removed to clean if
necessary.
1
Remove the air discharge louver.
Holding both ends of the air discharge louver,
remove it by sagging the center downwards.
2
Clean the air discharge louver with water.
If dirt is heavy, clean the air discharge louver using
tepid water with neutral detergent or just water.
3
Mount the air discharge louver.
First push in the one side, and insert the opposite
side by sagging the center downwards.
(2) Insert in the louver
sagging down the
center downward.
(1) Insert
NOTE
Insert the louver in the correct direction.
Insert the louver with the printed mark facing upwards,
and the arrow on the louver pointing in the outward
direction.
– 16 –
 Medium Static Ducted type
Air filter replacement
If appears on the remote control, replace the air
filter.
1
Push the button to stop the
operation, then turn off the circuit breaker.
F
1, 3
4
2
Replace the new air filter. (field supplied)
1) Remove the cover plate.
Remove the cover plate with 2 screws.
Cover plate fixing
screws
Cover plate
EN
32-EN