Audio Settings - Kenwood KMM-122 Mode D'emploi

AUDIO SETTINGS

While listening to any source...
1 Press AUD to enter [AUDIO CONTROL] directly.
2 Turn the volume knob to select an item (see the following
table), then press the knob.
3 Repeat step 2 until the desired item is selected or
activated.
4 Press and hold to exit.
To return to the previous setting item, press
(or using the remote control)
1 Press AUD to enter [AUDIO CONTROL].
Press J / K to select an item, then press
2
AUDIO CONTROL
SUB-W LEVEL –15 to +15 (0)
BASS LEVEL –8 to +8 (+2)
MID LEVEL –8 to +8 (+1)
TRE LEVEL –8 to +8 (+1)
10
ENGLISH
.
.
Default: XX
Adjusts the subwoofer output level.
Adjusts the level to memorize for each
source. (Before making an adjustment,
select the source you want to adjust.)
EQ PRO (This setting is stored to [USER].)
BASS ADJUST BASS CTR FRQ
BASS LEVEL
BASS Q FACTOR 1.00/1.25/1.50/2.00: Adjusts the quality factor.
BASS EXTEND
MID ADJUST MID CTR FRQ
MID LEVEL
MID Q FACTOR
TRE ADJUST TRE CTR FRQ
TRE LEVEL
PRESET EQ DRIVE EQ/TOP40/POWERFUL/ROCK/POPS/EASY/JAZZ/NATURAL/USER:
Selects a preset equalizer suitable to the music genre. (Select [USER] to use the
settings made in [EQ PRO].)
[DRIVE EQ] is a preset equalizer that reduces noise outside the car or running noise
of the tyres.
BASS BOOST LV1/LV2/LV3: Selects your preferred bass boost level. ; OFF: Cancels.
LOUDNESS LV1/LV2: Selects your preferred low and high frequencies boost to produce a well-
balanced sound at a low volume level. ; OFF: Cancels.
SUBWOOFER SET ON: Turns on the subwoofer output. ; OFF: Cancels.
LPF SUBWOOFER THROUGH: All signals are sent to the subwoofer. ; 85HZ/120HZ/160HZ: Audio
signals with frequencies lower than 85 Hz/120 Hz/160 Hz are sent to the subwoofer.
SUB-W PHASE REVERSE (180°)/NORMAL (0°): Selects the phase of the subwoofer output to be in
line with the speaker output for optimum performance. (Selectable only if a setting
other than [THROUGH] is selected for [LPF SUBWOOFER].)
60/80/100/200: Selects the center frequency.
–8 to +8 (+2): Adjusts the level.
ON: Turns on the extended bass. ; OFF: Cancels.
0.5KHZ/1.0KHZ/1.5KHZ/2.5KHZ: Selects the center frequency.
–8 to +8 (+1): Adjusts the level.
0.75/1.00/1.25: Adjusts the quality factor.
10.0KHZ/12.5KHZ/15.0KHZ/17.5KHZ: Selects the center
frequency.
–8 to +8 (+1): Adjusts the level.