Kenwood KMM-122 Mode D'emploi page 15

INSTALLATION/CONNECTION
Installing the unit (in-dash mounting)
Hook on the top side
Orientate the trim plate as
illustrated before fitting.
Part list for installation
(A) Faceplate
(D) Wiring harness
Do the required wiring.
( 16)
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
(B) Trim plate
(E) Extraction key
Dashboard of
your car
(C) Mounting sleeve
(F) Screws
When installing without the mounting sleeve
1 Remove the mounting sleeve and trim plate from the unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with screws
(supplied).
Use only the specified screws. Using wrong screws might
damage the unit.
How to remove the unit
1 Detach the faceplate.
2 Remove the trim plate.
3 Insert the extraction keys deeply into the slots on each side,
then follow the arrows as shown on the illustration.
15
ENGLISH