Gardeo PRO GPDCBT43 Traduction Des Instructions Originales page 88

INSTALLING PLASTIC GUARD
1, Movening the 2 screw from the guard
2, Aim at the thread hole with the clamp and guard
3, Tighten the screw
INSTALLING HARNESS
1, Adjust the harness hanger in a comfortable
Piston.
2, Buckle the harness at the hanger
REPLACE THE METAL BLADE TO
STRING HEAD
Disassembly metal blade
1, Align the hole on the gear box to the slot on the flange washer
2, Use pin to through the hole and slot and hold the flange washer
3, Loose the nut and remove the metal blade and cup washer
Assembly string head
4, Install the flange washer and cup washer on the spline shaft.
5, Align the hole on the gear box to the slot on the flange washer.
6, Use pin to through the hole and slot and hold the flange
washer.
7, Install the string head and tighten it
USE THE QUICK-RELEASE MECHANISM OF HARNESS
clamp
screw
Harness hanger
Harness
.
6
guard
clamp
WARNING
The edge of metal blade is sharp.
You need to wear gloves when
you installing or removing the
metal blade.