Gardeo PRO GPDCBT43 Traduction Des Instructions Originales page 87

ASSEMBLY INSTRUCTION
Knob
AL tube button
Connector
Hole
INSTALLING THE LOWER SHAFT
Take the lower shaft, meet the hole and the slot,
Then put the aluminum tube into the connector inside,
make sure the button have locked the hole,
Then turning the knob clockwise until it is tight
INSTALLING HANDLE
1, Installing "D" handle
D1 D2 D3
Refer to the pic D1~D3 , losse and take off the 4 screw and the upper clamp , Install the handle in
to the middle clamp , then locked the screw
5