Gardeo PRO GPDCBT43 Traduction Des Instructions Originales page 80

e) Always replace the cap of the fuel tank and tighten it
well after refueling.
f) If fuel is spilled , do not attempt to start the engine but
move the machine away spillages before starting .
g) Never refuel in a closed room.
h) Never house tool or fuel container in a room where an
open flame such as a water heater.
i) If the fuel tank is draining, it should be done outside.
6 . Storage and Maintenance
a) Remove any residue on the machine, check that no
part is damaged , if not repaired before the next use.
b ) Stop the machine and remove the spark plug before
maintenance work .
c ) Use only spare parts and accessories supplied or
recommended by the manufacturer . Never attempt to
repair the appliance yourself.
In fact , all jobs that are not specified in this manual may
only be done at stations after-sales service authorized by
us.
d) Drain the fuel tank , loosen the bleed screw for fuel
tank leaks, turn the machine on and let it run until it stops
itself.
e) Remove the spark plug and put a few drops of 2-stroke
engine oil .
Pull the starter cord 2-3 times , replace the spark plug to
the anchor point .
f ) Apply rust remover on parts such as metal contacts on
the cable metal acceleration , put the cover on the cutters
and store the machine inside to protect from moisture.
d) When the machine is stopped to perform maintenance
operations or to inspect the store , stop the engine ,
disconnect the spark plug wire and make sure all moving
parts have stopped. Allow engine to cool before
performing any inspection, adjustment , etc. .
e) Store the machine in a place where the fuel vapor will
not reach an open flame or spark. Always cool the
machine before storage.
f ) When transporting or storing the machine , always
mount the transport protection of the cutting device .
7. transport
- Make sure blade guards are in place.
- When transporting by vehicle, secure the machine with
a rope. Do not carry a motorcycle or bicycle because it is
dangerous.
- Never carry the trimmer on rough roads over long
distances without having previously removed the fuel
tank. Risk of leakage!
8. First aid
In case of accident make sure that a first-aid box is
available in the vicinity of the cutting operations.
Immediately replace any item taken from the first aid box.
When asking for help, please give the following
information:
- Place of accident
- What happened
- Number of injured persons
- Kind of injuries
- Your name
NOTE
People with circulatory disorders may experience injury
to blood vessels or the nervous system if exposed to
excessive vibration.
Vibration may cause the following symptoms in the
fingers, hands or wrists: Numbness, tingling, pain,
throbbing sensation, change in color of the skin or skin
changes.
If any of these symptoms, see a doctor!
Vibrations
After a long period of use of the machine, the vibration
may cause a disturbance of the blood supply of hands
("White finger disease").
It is not possible to set a valid period of use in general,
since the effect of vibration depends on several factors.
The following precautions help to prolong the duration of
use:
30