Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.
Activate the TRANSMITTER by holding the magnet
against the housing once and then removing it. The
LED built into the transmitter lights up. The POWER
LED on the RECEIVER stops blinking and the tuning-in
procedure is completed.
6.
Now the TRANSMITTER is tuned in to the RECEIVER
and the AS-5020.
3
TUNING IN MORE THAN ONE TRANSMITTER
(MAX. 8 DEVICES)
1.
Insert a battery (CR 2477) into the TRANSMITTER
to be tuned in.
2.
Press and hold the sensor (4) on the Receiver for
2 seconds. The CLOSED LED (5) begins to blink.
3.
Activate the TRANSMITTER by holding the magnet
against the housing once and then removing it. The
POWER LED on the RECEIVER stops blinking and the
tuning-in procedure is completed.
4.
Repeat steps a), b) and c) for each individual transmitter.
5.
Once a maximum of 8 TRANSMITTERS is tuned in, it is
impossible to add any more.
DELETING ONE OR ALL TRANSMITTERS
(MAX. 8 DEVICES)
Deleting individual TRANSMITTERS
1.
Press and hold the sensor (4) on the receiver for
2 seconds. The CLOSED LED (5) begins to blink.
2.
Activate the TRANSMITTER to be deleted by holding
the magnet against the housing once and then
AS 5020.3 Manual @150x180_06/2020.indd 15
is ready for use.
removing it. The POWER LED on the RECEIVER stops
blinking and the deletion procedure is completed.
Deleting all TRANSMITTERS
1.
Press and hold the sensor (4) on the receiver
for 2 seconds. The CLOSED LED (5) begins to blink.
2.
Press and hold the sensor (4) once more for 2 seconds.
The POWER LED on the RECEIVER stops blinking and the
deletion procedure for all TRANSMITTERS is completed.
FUNCTIONAL TEST
With (OPEN) switch position:
1.
Switch exhaust air device ON and open the window >
exhaust air device must switch on.
2.
Close the window > exhaust air device must switch off.
With (CLOSE) switch position:
1.
Switch connected device ON and open the window >
the connected device must switch off.
2.
Close the window > the connected device
must switch on.
MALFUNCTIONS
In individual cases cross-over with other similar
radio devices can cause malfunctions. In the normal
case it is sufficient to check the positioning of the
components and if necessary, to modify this.
EN
15
02.07.20 15:28
Publicité
Table des Matières
