Milk Frother - WMF LINEO Mode D'emploi

Start-up
Please clean all parts described in the "Cleaning and care" section before allowing
them to come into contact with food.
Chopper
With the chopper, you can chop and mince, onions, fruit, vegetables, hard cheese,
herbs, nuts and meat.
▪ Remove the protective cover from the knife.
Place the stainless steel knife into the receptacle at the bottom of the container.
Turn the stainless steel knife until it slides to the bottom of the receptacle.
▪ Attention: The blades are sharp. For this reason, always replace the protective
cover when the blades are not in use.
Place the food in the container so that it is no higher than the MAX marking and
place the upper part with the integrated adapter on top.
For better stability, attach the rubber anti-slip base to the bottom of the
container.
Attention: Fill with a maximum of 200ml of thin liquid food.
▪ Insert the drive unit of the hand-held blender on the adapter integrated into
the upper part. Press the coupling of the drive unit onto the adapter until the
container with the upper part audibly clicks into place and is therefore locked.
There may be no gap between the drive unit and the adapter.
▪ Use the rotary ring to select the desired speed. Use a higher speed for harder
food.
▪ After connecting the mains plug, press the on
until you achieve the desired result. Hold the container with one hand during the
process. Alternatively, you can also press the turbo button
device then operates at full speed.
▪ Once the desired result is achieved, wait until the motor and knife stop and
disconnect the mains plug.
▪ Loosen the upper part from the drive unit by pressing the unlock button. You can
then remove the upper part from the container and carefully remove the knife.
▪ Do not use the container for storing food.

Milk frother

With the milk frother, you can froth milk, e.g. for cappuccinos, latte macchiatos or
even desserts.
▪ Attach the adapter by inserting it into the milk frother with light pressure. The
adapter audibly clicks into place.
▪ Attach the adapter down onto the coupling of the drive unit and push it against
the drive unit until the milk frother audibly clicks onto the drive unit and is
therefore locked. There may be no gap between the drive unit and the adapter.
The milk frother must sit firmly on the device and should not be loose or fall off.
▪ Pour milk into a container with a high rim and insert the milk frother into this
container.
▪ Use the rotary ring to select the desired speed.
After connecting the mains plug, push and hold the on-switch
desired result is achieved.
Alternatively, you can also press the turbo button
then operates at full speed.
12
switch in multiple short bursts
to process. The
until the
to process. The device