Restube automatic Mode D'emploi page 25

Oral valve test
Remove the cap from the valve and depress the oral valve in order to allow some CO2
to escape. Afterwards, the oral valve should be completely sealed again. Next, empty
the float entirely via the oral valve. Next, inflate the float via the oral valve until it is
firm, using only your breath to do so.
Air-tightness of the float
Having completely inflated the float by blowing into it, leave it somewhere where the
temperature is stable for 24 hours. Should it lose a lot of air during this period, the
product will need to be replaced. NOTE: Pure CO2 slowly diffuses through the material
which the buoy is made of. It is therefore normal for the float to slowly empty over a
period of 15-30 hours if it has been filled with pure CO2 from the cartridge.
Getting ready for the next use
Pack the dry RESTUBE product up according to its packing instructions. Ensure that the
old cartridge, which has been pierced and has a hole, is replaced with a new, intact
one. NOTE: Only use genuine RESTUBE CO2 cartridges, as the inflation function can
otherwise be adversely affected. The cartridges conform to EN ISO 12402-7 as well
as UL 1191. They are 1. made to fit the trigger and have a very thin pierceable cap,
2. weighted for the exact amount needed to fill the buoy and 3. are very resistant to
sea water.
Disposal
Bag and belt can be disposed of in the general waste. The CO2 cartridges can only be
disposed of in the general waste if they are empty.
Help us to make everyone freer and safer in the water!
Show other water-lovers how you use your Restube. Post a picture of yourself with a
Restube on Facebook or Instagram, link to @restube.official and #restubemoment
and write about your special RESTUBE experience. We look forward to hearing from
you!
Thanks for your help, the RESTUBE team
25