Level Washer - Maytag MAT20CSAGW Instructions D'installation

LEVEL WASHER

IMPORTANT: Level washer properly to reduce excess noise
and vibration.
1. Move the washer to its final location. Place a level on top
edges of washer. Use side seam as a guide to check levelness
of sides. Check levelness of front using lid, as shown. Rock
washer back and forth to make sure all 4 feet make solid
contact with floor.
Place level here
Place level here
Not Level
10
Place level here
Place level here
LEVEL Not Level
2. Use a 14 mm or 9/16" open-end or adjustable wrench to turn
jam nuts clockwise on feet until they are about 13 mm (1/2")
from the washer cabinet. Then turn the leveling foot clockwise
to lower the washer or counterclockwise to raise the washer.
Recheck levelness of washer and repeat as needed.
HELPFUL TIP: You may want to prop up front of washer about
102 mm (4") with a wood block or similar object that will support
weight of washer.
Jam nut Jam nut
3. When washer is level, use a 14 mm or 9/16" open-end
or adjustable wrench to turn jam nuts counterclockwise
on leveling feet tightly against washer cabinet.
Jam nut
Jam nut