Stadler Form Tim Mode D'emploi page 6

• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• If the supply cord is damaged, it must be replaced by the manufacturer, or
its service agent, or a qualified person in order to avoid a hazard.
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
• Only use the adapter provided by the manufacturer.
Assembly (see page 2 and 3)
Attach the foot (1) to the bottom of the housing (2) using the screw provided.
Make sure that the screw is tightened firmly.
Setting up / operation
1. Place Tim in the desired position on a flat surface. Connect the USB
cable (3) to the power adapter (4) and to the appliance (5) and insert the
adapter into a suitable socket. Alternatively, you can also connect the
USB cable to another power source such as a PC or an external battery
(battery pack/power bank with min. 2A).
2. To switch on the appliance, gently turn the controller (6) in a clockwise
direction until you hear a click. The speed settings of the fan blades
(9) range from gentle breeze to strong wind and can be continuously
adjusted by turning the controller in a clockwise direction.
3. To switch off the appliance, turn the controller (6) in an anti-clockwise
direction until you hear a click.
4. To change the position of the fan ring (7), gently turn the fan ring (7) to
the left or right.
5. To change the angle of inclination of the fan ring (7), hold the side of
the outer ring with one hand and tilt the fan ring in the desired direction
with the other.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (3+4) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).