Settings; Changing Direction Of Rotation [1-4]; Changing Gear [1-6]; Fastening - Festool T 18+3 Li Guide D'utilisation

Inserting the battery pack

Slide the battery pack upwards into the machine
like shown in Fig. 2 until it engages.
BP/C 18
2
Consider the pictures on the fold-out page.
CAUTION
Risk of injury

Always switch off the power tool before adjusting

settings!

Changing direction of rotation [1-4]

• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation

Changing gear [1-6]

• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
WARNING
Risk of injury

Always disconnect the battery pack before per-
forming any type of work on the machine!
2-1
Settings
Adjust the switch so that its marking [1-9] faces the
screw symbol [1-8].
Adjust the torque accordingly at the torque wheel
[1-12].
Position 1 = low torque
Position 25 = high torque
An acoustic signal sounds when the preset torque
is reached and the machine then switches off. You
must release and press the ON/OFF switch [1-3]
again to start the machine.
Adjust the switch so that its marking [1-9] faces
the drilling symbol [1-7] = maximum torque.

Tool holder, attachments

Hot and sharp tools
Risk of injury

Do not use insert tools that are blunt or defec-
tive.

Wear protective gloves.

Fastening

Drilling

CAUTION
11