Assembly - Delta 31-260X Manuel D'utilisation

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and
removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.
HOW TO ASSEMBLE THE STAND
1. Select one of the side pieces (A) Fig. 1A and attach one of the feet (B) to it with the short end of the foot to the front
of the machine, using two M8-20 bolts (C) with two M8 flat washers. Attach the other foot to the other side piece.
2. Attach the back brace (D) to the two side pieces with M8-20 Carriage Bolts and Nuts.
3. Attach the center piece (E) to the rest of the assembly with M8-20 Carriage Bolts and Nuts. Tighten all hardware
securely.
A
B
C
Fig. 1A
HOW TO ATTACH THE SANDER TO THE STAND
This machine is heavy. Use two or more people when lifting.
1. Place the machine on its end (Fig. 2), resting on the
two wood blocks (not supplied). Attach the stand.
2. Position the front of the stand (large black panel (E)
Fig. 1C) on the front of the machine (power switch
side). Match the holes in the stand with those in the
machine. Insert the M8-20 bolts and secure with the
M8 Flange Nuts.
HOW TO ATTACH THE LEVELING FEET TO THE STAND
1. The jam nut should already be on the leveling foot. If
not, place the jam nut (A) Fig. 2A on the leveling foot
(B).
2. Screw the leveling foot with the jam nut into the hole
provided on the leg.
3. CAREFULLY lift the machine upright.
4. Level the machine by turning the leveling feet (B) one
way or the other. When the machine is level, tighten
the jam nuts (A).
5. Insert the end caps into the ends of the legs.

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
1/2" Open-end wrench
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1-2 hours.
Fig. 1B
1/4" Hex wrench
D
7
E
Fig. 1C
Fig. 2
A
B