Electrical Connection - Miele PAC 1045 Mode D'emploi

en - Installation
56

Electrical connection

The air purifier is supplied with a mains cable with moulded plug
ready for connection to an earthed socket as standard.
The socket must be easily accessible after the air purifier has been in-
stalled. If the socket is not easily accessible, ensure that a suitable
means of disconnection is provided on the installation side for each
pole.
 Risk of fire from overheating.
Connecting the air purifier to multi-socket adapters or extension
cables can overload the cables.
For safety reasons, do not use an extension cable or multi-socket
adapter.
The electrical installation must comply with VDE 0100 requirements.
For safety reasons, we recommend using a type A residual current
device (RCD) in the assigned electrical installation for connecting the
air purifier.
If the mains connection cable is damaged, it must only be replaced
with a specific mains connection cable of the same type (available
from the Miele Customer Service Department). For safety reasons,
such replacement may only be carried out by a qualified specialist or
the Miele Customer Service Department.
These operating instructions and the data plate indicate the nominal
power consumption and the appropriate fuse rating. Compare this in-
formation with the data of the on-site electrical connection.
If in any doubt, consult a qualified electrician.
Do not connect the air purifier to a stand-alone inverter such as those
used with an autonomous energy source, e.g. solar power. When the
air purifier is switched on, power surges could result in an auto switch
off. This could damage the electronic module.