Control Panel - Miele PAC 1045 Mode D'emploi

Control panel

Overview of oper-
ating modes
Overview of oper-
ating statuses
1 2 3
Control panel behind the lockable access flap
a
 button
b
 button
c
 button
d
Green LED 
Flashes when starting/ready for use, lights up during operation.
e
Yellow LED CO  
2
Flashes in the event of a CO
active.
f
Red LED 
Flashes in the event of a fault.
Manual mode During operation, the fan speed can be changed individually between 20–100 %
in 5 % increments via the  and  buttons.
Optional initial flow can be switched on before normal operation.
Manual+time
Same as
mode used to set a switch-on time and switch-off time for each day.
CO2 mode The fan speed is automatically regulated according to the set room size. The need
for ventilation is indicated via an LED and a display message.
Optional initial flow can be switched on before normal operation and a circulation
function can be activated.
CO2+time mode
Same as
to set a switch-on time and switch-off time for each day.
The following operating statuses are shown in the display:
Ready for opera- The power supply has been connected and the appliance is ready for operation.
tion
Flow The fan runs at a set flow rate and duration to clean the air before the air purifier
switches to normal operation.
Manual opera- The appliance is in normal operation.
tion
Manual+time
operation
CO2 operation
CO2+time oper-
ation
ThermoControl Relevant pathogens are deactivated automatically by Miele ThermoControl after
every use.
active
Fan run-on The fan keeps running after Miele ThermoControl in order to cool the filter.
Intensive circ. The fan runs at a higher speed for a short period in order to quickly circulate the
air within the room.
active
en - Using the machine
6
5
4
warning, lights up when heating is
2
Manual mode
but with additional clock function (timer) which can be
CO2 mode
but with additional clock function (timer) which can be used
45