Rowenta DG5030 Mode D'emploi page 6

When the steam indicator light turns off
(approximately 7 minutes), steam is ready.
Hang the garment on a coat hanger and hold
the fabric from the bottom of the garment
slightly taut with one hand.
Holding the iron in a vertical position, press
continuously on the steam button while
moving the iron from the top of the garment to
C
the bottom ( ).
7 • Filling the boiler while in
use
Caution : Never unscrew the boiler cap while
iron is producing steam and boiler is under
pressure.
Before opening the boiler, ensure that there is
no steam inside. To do this, press the steam
button and keep it pressed until there is no
more steam.
MAINTENANCE AND CLEANING
Before cleaning ensure that the appliance is unplugged and completely cooled down. The iron Before cleaning ensure that the appliance is unplugged and completely cooled down. The iron
can be cleaned with a damp cloth and wiped dry. Never use household cleaners, descalers or can be cleaned with a damp cloth and wiped dry. Never use household cleaners, descalers or
solvents. solvents.
9 • Cleaning the soleplate
In normal use a draggy coating may build up
on the soleplate (starch, detergent buildup,
burnt synthetic fibers). This can be easily
removed by using the Rowenta Soleplate
Cleaning Kit or a quality hot iron soleplate
cleaner available at most stores.
To prevent scratching of the soleplate, do not
iron over sharp objects (zippers, etc.). Do not
place the iron on rough surfaces, e.g. metal
iron support, which may scratch the soleplate.
Place the iron on its rest on top of the base of
the unit.
Always put the iron with the soleplate down on
the iron rest, never place on its heel.
10 • Rinsing out the
boiler
Do not use descaling agents.
To ensure optimum steam performance, the
boiler must be rinsed out after every 10 uses.
If your tap water is hard increase the
frequency.
6
Turn the unit off (see section "Turning On and
Off") and unplug from outlet.
Slowly unscrew the boiler cap. Using a water
pitcher, fill with 33 oz. of water. Do not fill
water tank past the base of the boiler cap
thread. Be sure that water does not spill over.
If this occurs remove the excess water.
Replace the boiler cap and screw it on tightly.
Plug back in to electrical outlet.
8 • After ironing
Turn the unit off. (Consult section "Turning On
and Off").
Unplug the appliance.
Place the iron on the iron rest and allow to cool
completely which will take approximately 1
hour.
Once cold, empty water from the appliance
before storing. We recommend emptying the
boiler when not in use.
Check that the generator is unplugged and
cold.
Fill the boiler 3/4 full with tap water.
Shake the boiler for a few moments and then
empty it over a sink (
Repeat the process.
Wipe the generator base regularly with a damp
cloth and wipe dry.
Never hold the generator under the tap.
Boiler Cap
To ensure a proper seal, please check the red
rubber ring in the safety cap for wear and
tear regularly. If wear is noted, replace ring.
Replacement rings are available through our
main service centers.
D
).