Alarm Input; Alarm Buffer - Abus TVIP20000 Manuel Utilisateur

Accept the settings by pressing "OK" or cancel them by pressing "Cancel".

6.14 Alarm input

Alarm input: The properties of the digital switch input are configured here. This input can then be
used as a trigger for processes (e.g. FTP, SMTP alarm reactions).
Sensor input: Activate the digital input by ticking the box (one input is available here).
Trigger condition: Switch type of the digital input.
High: The digital input is active when connected to the power supply.
Low: The digital input is active when disconnected from the power supply.
The switching modes of the digital input can be found in section 4.3 "Alarm input
and output".
Accept the settings by pressing "OK" or cancel them by pressing "Cancel".

6.15 Alarm buffer

This function can be used in connection with various functions (e.g. FTP, SMTP, alarm output or saving data
on a network drive). When activated, the video data is pre-recorded and post-recorded in the internal memory.
Alarm buffer:
[VGA] Video mode:
Recording capacity:
Pre-alarm period:
Post-alarm period:
Recording time:
Pre-alarm period:
Post-alarm period:
Activates or deactivates the alarm buffer.
The mode is set permanently to MPEG-4.
Displays the maximum available capacities for pre-recording and post-
recording.
Pre-recording time (in seconds).
Post-recording time (in seconds).
Settings for the maximum pre-recording and post-recording time.
Setting of the pre-recording time (in seconds). This value cannot exceed the
available pre-recording capacity.
Setting of the post-recording time (in seconds). This value cannot exceed the
available post-recording capacity.
131
English