Troubleshooting - Ryobi P2809 Manuel D'utilisation

PROBLEM
Unit has trouble priming /
doesn't spray when tank is
filled.
Unit sprays improperly.
Unit is "spitting".
Spray is weak.
Unit runs for a short period
then shuts off.
This product has a Three-year Limited Warranty
For warranty details, visit www.ryobitools.com

TROUBLESHOOTING

POSSIBLE CAUSE
Pump has lost its prime.
Nozzle is clogged or fluid in
tank is low.
Liquid in tank is too thick.
Solution is too thick.
Battery needs charging.
Solution is too thick.
for personal, family, or household use.
or call (toll free) 1-800-860-4050.
Turn the nozzle selector dial to the largest micron setting.
Once spray begins, release the switch trigger and rotate
the nozzle selector dial to the desired position.
Make sure there is sufficient fluid in the tank.
Clean nozzles.
Empty the tank, clean both the tank and filter, then try
again. Make sure that all chemicals/liquid used in the
sprayer are as thin as water.
Make sure that all chemicals/liquid used in the sprayer
are as thin as water.
Recharge the battery.
Make sure that all chemicals/liquid used in the sprayer
are as thin as water.
11 — English
SOLUTION