Safety Precautions - PeakTech 1035 Mode D'emploi

Safety precautions

This product complies with the requirements of the following
European Community Directives: 2004/108/EC (Electromagnetic
Compatibility) and 2006/95/EC (Low Voltage) as amended by
2004/22/EC (CE-Marking). Overvoltage category III 600V; pollution
degree 2.
CAT I: For signal level, telecommunication, electronic with small
transient over voltage
CAT II: For local level, appliances, main wall outlets, portable
equipment
CAT III: Supplied from a cable under earth; fixed installed switches,
automatic cut-off or main plugs.
CAT IV: Units and installations, which are supplied over aerial line,
which are stand in a risk of persuade of a lightning, i.e.
main-switches
current use counter.
Warning! Do not use this instrument for high-energy industrial
installation measurement. This instrument is intended for use in
installation overvoltage category III (600V AC/DC, 10A). To ensure
safe operation of the equipment and eliminate the danger of serious
injury due to short-circuits (arcing), the following safety precautions
must be observed.
The meter is designed to withstand the stated max voltages. If it is not
possible to exclude without doubts that impulses, transients,
disturbance or for other reasons, these voltages are exceeded a
suitable prescale (10:1) must be used.
* Do not exceed the maximum permissible input ratings (danger of
serious injury and/or destruction of the equipment).
* Replace a defective fuse only with a fuse of the original rating.
Never short-circuit fuse or fuse holding.
on current
-15-
input, overvoltage-diverter,