A Kensington lock slot is found under the lights.
Back Panel
The back panel of the device has an RJ-45 Ethernet port. Use the Ethernet port to
power your device using PoE. It is an auto-sensing, Gigabit Ethernet (802.3) port
used to connect your WAP devices to network devices, such as computers, routers, or
switches. We strongly recommend that you use a Category 5e or better cable for
gigabit connectivity.
The back panel of the device has a Reset button. See
Returning them to their Factory Default Settings"
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco Small Business RV Series router, the default range for the
DHCP assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Cisco Small Business WAP371 Series Wireless Access Point
Default Value
cisco
cisco
DHCP address assigned by
server
192.168.1.245
255.255.255.0
"Rebooting the Devices or
for information on the Reset button.
3