Air Filters - Domo DO324A Mode D'emploi

Table des Matières

Les langues disponibles

After fully draining the water tank, place the drain plug back on the drain opening.

Restart the unit, make sure the error code P1 is no longer displayed. When the code doesn't disappear,

try turning off and on the unit a few times. When the error code continues, please contact the after

sales service.

NOTE : always make sure to install the drain plug, before turning the unit back on.

CLEANING

Always remove the plug from the socket before cleaning the unit.

Never use any chemical or abrasive products to clean the unit.

Never clean the unit with water or any other liquid, this can cause electrocution.

When the power cord is damaged it must be repaired or replaced by the after sales surface of the

manufacturer or by a qualified person.

Air filters

The unit contains 2 air filters. Clean the air filters at least every 2 weeks.

This prevents the fan from malfunctioning due to dust in the filter.

Clean the filters in lukewarm water with a mild detergent. Rinse the

filters thoroughly and let them air dry.

When the filters are completely dry, you can put them back in the unit.

Airco body

Use a damp, soft cloth and a bit of mild detergent, to clean the outside of the unit. Make sure the unit is

thoroughly dried afterwards.

Storing

Before storing the unit for a longer periode of time, please follow the next steps :

Drain all the water from the appliance.

Afterwards turn on the unit in the "fan" mode for half a day. Make sure the unit is placed in a heated

room. This will dry the unit completely and previent the forming of mold.

Turn off the unit, remove the plug from the socket and remove the batteries from the remote control.

Clean the filters and place them back in the unit.

Store the unit in a dry, dark place.

POSSIBLE PROBLEMS AND THEIR SOLUTIONS

The appliance isn't working when pressing the on/off touch.

The error code P1 is dispayed , drain the water from the airco.

The room temperature is lower than the selected temperature. Adjust the selected temperature.

The room is not cool enough.

The windows and doors aren't closed. Make sure all windows and doors are closed.

There are heat sources in the room. Remove all heat sources if possible.

DO324A

Table des Matières