Troubleshooting; Display Problems - VDO Oceanlink Master Notice D'utilisation

Troubleshooting

Display problems

Problem
The displayed values are not those
expected
"--" and not the expected value appears on
the display
Problems on connected 52 mm gauges
Problem
The gauge is backlit but the pointer
does not move
The pointer does not move and the
gauge is not backlit
34 Tachometer | Operating instruction v. 1.0 | A2C15587700 | 05-2017 | © 2017 Continental Automotive Switzerland AG
Cause
Incorrect sensor
configuration
Incorrectly connected
sensor
The NMEA 2000 network
backbone was incorrectly
created
Data not available on the
network
Sensor not connected
The NMEA 2000 network
backbone was incorrectly
created
Cause
Data not received from master
Master not powered
No 52 mm chain gauge is
connected to the master
Solution
Check parameter settings in the settings menu,
in Config analog inputs
Check the connection, see installation
instructions
Check connections and make sure there is a
termination at the beginning and end of the
backbone
Wait
Connect the sensor, see installation instructions
Check connections and make sure there is a
termination at the beginning and end of the
backbone
Solution
Check whether the 52 mm gauge is
compatible with the master
Check master connections
Connect the power supply
Connect a 52 mm gauge to the master