Alarms; Alarm Signal - VDO Oceanlink Master Notice D'utilisation

Alarms

Alarm signal

When an alarm is triggered, "New alarm" briefly appears on the display followed by the specific alarm
message and buzzer (if connected). The message remains on the screen and the buzzer sounds until
the alarm is acknowledged.
Note: alarms are not signaled when setting up the device.
If, after acknowledgment, at least one alarm is still active, "AL" blinks in the data pages.
Managing alarms
1. To acknowledge an alarm, briefly press the button: if other alarms were triggered (new or already
acknowledged), the next alarm message appears. For the alarm display order, see "Managed alarms
list" on the next page.
2. To scroll alarms, briefly press the button: "Exit alarms" appears after the last alarm in the list.
3. To scroll the alarm list again, select No. To exit the alarm list, select Yes: the data page displayed
before the new alarm was triggered appears.
4. To scroll the alarm list, scroll all data pages until "Alarm" appears and hold down the button for 3
seconds.
32 Tachometer | Operating instruction v. 1.0 | A2C15587700 | 05-2017 | © 2017 Continental Automotive Switzerland AG