Using The Settings Menu; Settings Description - VDO Oceanlink Master Notice D'utilisation

General settings

Using the settings menu

To...
open the settings menu
scroll the possible values or commands Yes and
No
confirm the value or command and move to the
next setting
exit the settings menu
Note: settings can only be scrolled forward. To change a previous setting, exit the settings menu and open it
again.
Example procedure
Following is the procedure to set Engine instance = 3
1. Turn on the device holding down the button until "Settings" appears: the Config units setting
appears.
2. Hold down the button until No blinks once: the Config engine instance setting appears.
3. Briefly press the button to view Yes, then hold it down until Yes blinks once: the Engine instance
setting appears with the current value.
4. Briefly press the button to scroll values until 3 is displayed.
5. Hold down the button until it blinks once: the Config analog inputs setting appears.

Settings description

Setting
Speed
Temperature Temperature units of measure
Pressure
Volume
Depth
Engine
instance
Input pin 8
Input pin 9
Do sens.
calibration
Config RPM
Offset
UTC offset
TimeFormat
28 Tachometer | Operating instruction v. 1.0 | A2C15587700 | 05-2017 | © 2017 Continental Automotive Switzerland AG
Description
Speed units of measure
Pressure units of measure
Volume units of measure
Depth units of measure
Displayed data engine, NMEA 2000 code.
Type of sensor data on input 1
Type of sensor data on input 2
Start sensor calibration
Impulses per engine revolution
Value to be added/subtracted from the depth to
compensate for the transducer position compared to the
waterline or keel
Time zone
Time format
Then....
turn on the device holding down the button until "Settings" appears: the
Config units setting appears
briefly press the button
hold down the button until the value or command blinks once
select the setting Exit settings and then the command Yes or turn the
device off and back on: the first data page appears.
kmh/ mph/ kts
°C/ °F
bar/ PSI/ kPA
Ltr/ gal
ft/ mtr
0/ 1/ 2/ 3
Off: no connected analog sensor
l
Trim: trim, propeller tilt
l
Fresh: fresh water level
l
Fuel: fuel level
l
Rudder: rudder angle
l
For information on sensor calibration, see "Sensors
calibration" on page 30.
From 0.0 to 999.9 (default = 1.0)
From -99.9 to + 99.9
From -12 to +12 h
12 h
l
24 h
l
Possible values/commands*