Operating Instructions; Use Of The Control Panel; Power Function - Brandt TI2005 Manuel D'instruction

2.3 Operating instructions

2.3.1 Use of the control panel :

The sensitive pads work with a sense of touch. It is not necessary to put pressure on.

Use the base of your finger and not the tip as indicated on the images below

Slide your finger on the slider to increase or decrease the power.

You will hear a beep each time an action will be registered.

The control panel must be clean, dry and not be covered by an object or a cloth; even a thin

layer of water can create dysfunction.
2.3.2 Starting:
After the power supply is connected, the buzzer sounds and the screen show"L" blinking, indicating
that the hotplate is in a state of standby. So that the appliance is ready to be programmed, press on
(1) and the LED will blink in order to indicate you that it is ready. After used, the surface of the
hotplate is hot, the screen show "H" blinking.
Never put an empty container on the ceramic plate before switching on the
appliance.

2.3.3 POWER Function:

To select the power intensity press the +/- buttons. In case there is no pot or unsuitable
pots in the appliance, it will emit a sound. The induction cooker will shut down automatically after
one minute. You can select 8 different level of power.
2.3.4 Timer:
To use the timer, press the (2) pad. The digital screen will indicate « 0 : 00 ». During the next 4
seconds, press on the +/- pads to adjust the cooking time. Each pressure increases or decreases
the time of 1 minute. If you maintain the pad longer, the time will increase or decrease by
increments of 10 minutes. The timer can be set from 1 minute to 180 minutes. Once the time is set,
the digital screen will flicker during 5 seconds before heating. To cancel the timer function, press
again on the (2) pad but this time during 3 seconds.
For all levels of heating, the cooking time is by default 2 hours.
2.3.5 « Boost » function :
The (3) pad allows obtaining directly the highest power level. By pressing again the (3) pad the
appliance will go back to the power of origin.
(1) (2)
22
(3)