AYA ART130TU Manuel D'utilisation page 40

1.Remove the two screws. (6) securing the top. Remove the top (7)
2.Remove the 2 screws holding the top hinge (5) on the body.
3.Remove the top hinge (5).
4.Lift and remove the refrigerator door. Store it on an area without the risk of damage.
5.Remove the 2 screws (8) holding the bottom hinge (2). Remove the bottom hinge (2).
6.Unscrew the left foot (4) and screw it on the right side.
7.Then position the lower hinge (2) on the opposite side and attach it with 2 screws (8).
8.Reset the rod (8) on the bottom hinge (2).
9.Position the refrigerator door on the bottom hinge.
10.Then position the top hinge (5) in the freezer door, place the whole assembly on
the opposite side. Position the refrigerator door in the condition 'closed' and fix the top
hinge (5) with 2 screws (1).
11.Attention, before tightening the screws (1 and 8), check that the door is properly
aligned on the body.
12.Install the top, screw it the screws (6).
7.TROUBLE SHOOTING
In case of malfunction, you can solve many common problems easily.
1. Your refrigerator will not operate...Check if
-- The power supply cord is unplugged.
-- The thermostat knob is set to OFF position.
2. The light so not work...Check if
- 38 -