Publicité
Les langues disponibles
Les langues disponibles
OPERATION
Blowing Feature
Your Vac features a Blowing Port. It can
blow sawdust and other debris. Follow the
steps below to use your Vac as a Blower.
1. Locate the Blowing Port, at the rear of
the Powerhead of your Wet/Dry Vac.
2. Align the Hose Release Button of the
Tug-A-Long Positive Locking Hose with
Dual-Flex End with the Ridges on the
Blower Port. Push the Hose End straight
into the Blower Port until the Hose
Release Button fully engages the Blower
Port Ridges.
3. (Optional) Attach the Extension Wand
to swivel end of the Hose. See Locking
Accessories section of this manual for
instructions on connecting the Locking
Accessories.
4. Turn the Vac on and you are ready to
use your Vac as a Blower.
WARNING: Always wear safety
!
eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before
using as a blower.
WARNING: To reduce the risk
!
of injury to bystanders, keep them
clear of blowing debris.
CAUTION: Wear a dust mask if
!
blowing creates dust which might
be inhaled.
Remove Hose:
1. Rotate Hose End in either direction to
disengage Blower Port Ridges.
2. Press the Hose Release Button and
pull the Hose End straight out of the
Blower Port.
INSERT
HOSE
Blower Port
Ridges
REMOVE
HOSE
1
2
12
Hose
Release
Button
1
Publicité
Chapitres
