Cembre HTEP-S Notice D'utilisation Et Entretien page 4

ENGLISH
3. CONDUCTOR ASSEMBLY
3.1)
Insert the special bolt (with recessed head) through the copper bush. The screw thread should
protrude from the fl ange side of the bush; the recessed bolt head will tighten onto the web
of the rail and not onto the bush (Fig. 8).
3.2)
Crimp the lug onto the conductor. Assemble the lug to the fl ange of the bush over the pro-
truding bolt.
3.3)
Fit the fl at washer and the self-locking nut (Fig. 9).
4. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of the tool.
4.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove any residual,
especially close to pivots and moveable parts.
4.2) Storage
(Ref. to Fig. 11)
When not use, the tool should be stored and transported in the steel case, to prevent damage.
Steel case: VAL HTEP: size 465x193x61 mm (18.3x7.6x2.4 in.); weight 2,5 kg (5.5 lbs).
The case will also store the "GO/NO GO" gauge CAL... and the two plungers OG...
5. MAINTENANCE
Air in the hydraulic circuit may aff ect the performance of the tool; e.g. no ram advancement, slow
advancement of the ram; ram pulsating.
In this case proceed as follows:
5.1) To purge air bubbles from hydraulic circuit
a – Hold tool upright in a vice with handles open (Fig. 10).
b – Unscrew the main handle (03) from the body (12) to expose the rubber oil reservoir (02).
c – Remove reservoir cap (01).
d – Operate moveable handle (39) several times, in order to advance the ram (27).
e – Press the pressure release lever (51) to retract the ram, discharge oil pressure from the circuit
and return all oil to the reservoir.
(Ref. to Figg. 8 and 9)
(Ref. to Fig. 10)
4