Mounting And Wiring The Warning Plates And Lighting - Vicon ANDEX 773 Notice De Montage

EN
S
S
Fig. 3-17
Fig. 3-18
Fig. 3-19
16
V
3.11 Mounting and wiring the
warning plates and lighting
Slide the right and left warning plates and the
pre-mounted lighting onto the chassis frame and
fasten with screws (fig. 3-17). Use the content of
bag F.
The electric line for the lighting is passed through
the cable routing on the rear frame member using
the insertion aid and connected to plug (V) (fig.
3-18).
Note:
Take care that the warning stripes
always face outward.
The side lights must face to the front and the
combined light with indicator lamp and stop light
to the rear. Observe the markings [R] and [L] for
right and left connector. The distributor connector
is mounted to the rear cross bar and secured.
Guide the cable through the wiring duct on the
rear support. On the middle and front part of the
frame, the cable and the hydraulic lines meet and
are tied with cable binders (fig. 3-19). Use the
content of bag F.
Attention!
Lay the cable so that it cannot get
stuck, caught or scrub!
As the cable length needed varies from tractor to
tractor, the extra cable has to be tied up.