Partially Mounted Helipede Rotary Windrower; Turning The Wheels And Axles Outwards; Mounting The Chassis Frame; Mounting The Control Bars - Vicon ANDEX 773 Notice De Montage

EN
C C C C C
B B B B B
A A A A A
D D D D D
Fig. 2-1
Z
M
C
Fig. 2-2
Fig. 2-3
6
Z
B
B
L
Z
H
U
2 Partially mounted Heli-
pede Rotary Windrower
2.1 Turning the wheels and axles
outwards
To this end, remove dowel pins (A + B) from control
lever (C). Turn axle (D) outwards (fig. 2-1).
2.2

Mounting the chassis frame

For mounting, see chapter 3.4. and fig. 3-3.
2.3

Mounting the control bars

The front and middle part of the control bar are
pre-assembled with the plastic bearing clamps and
connected with bolt (Z).
Connect the middle part (M), the rear part (H) of
the control bar and the reversing lever (U) using
bolt (B) and secure with split pin and washer.
Control bars (L) are connected to control lever
(A) with bolt (Z) and secured with split pin and
A
washer.
Control levers (A) must face forward in direction
of travel (fig. 2-2).
The wheels then face outward. Use the
corresponding pre-assembled bolts for the above
mounting.
When fitting the „2 single swaths" option, install
steering cylinder (C) instead of the front steering
rod.
2.4

Mounting the TerraLink chassis

The wheel axles of the rear and front rotor have
different track widths (L). Fit the wheel axle with
small track L to the rear rotor and that with large
1
track L to the front rotor.
2
Check the adjustment of the rotor pitch after
installation, see Operator's Manual, section 3.4.