Mounting The Wheels; Mounting The Warning Plates; Mounting The Lighting - Vicon ANDEX 773 Notice De Montage

R
20Nm torque 20Nm torque 20Nm torque 20Nm torque 20Nm torque
Fig. 2-7
Fig. 2-8
Fig. 2-9
K
E
E
V
2.5

Mounting the wheels

Mount the 16" wheels as shown in fig. 2-7.
Attention!
The wheel nut (R) may only be
tightened with a torque of 20 Nm to
avoid damaging plastic ring (K) (fig.
2-7).
2.6

Mounting the warning plates

Note:
Please observe that there is a warning
plate for the right-hand and left-hand
side.
Fasten each plate to the chassis frame with 8
screws (E), leaving as great a distance as possible
between the plates (fig. 2-8). Use the content of
bag F.
2.7

Mounting the lighting

The side lights must face to the front and the
combined light with indicator lamp and stop light
to the rear.
For information on mounting the electric cables,
see chapter 3.10 on page 17.
EN
7