Hilti SI­-AT-­A22 Mode D'emploi Original page 18

5.7.1 Setting the operating mode with the control panel buttons
1. Unlock the torque module. → page 7
2. Use the arrow buttons to move the selection frame, as necessary, to the
option you want to change.
3. Press the OK button.
▶ A black background appears behind the option you selected.
4. Use the arrow buttons to select the desired setting.
5. Press the OK button.
▶ The selected setting appears in the selection frame.
6. Repeat the last 3 steps as necessary to make other changes.
7. Lock the torque module. → page 7
5.7.2 Setting the operating mode by scanning the barcode or QR code
5
1. Unlock the torque module. → page 7
2. Press the "Scan" button.
▶ The scanner is activated and the
to indicate that the scanner is ready.
3. Hold the module facing the barcode or QR code at a distance of
approx. 15 centimeters (6"), so that the code is inside the frame projected
by the scanner.
▶ The LEDs show green.
▶ The confirmation tone sounds.
▶ The operating mode for the product to be tightened appears on the
display.
▶ The LEDs flash red.
▶ The warning tone sounds.
appears on the display (code could not be read or was not
▶
recognized).
▶ Press the "Scan" button and scan the code again.
Operating parameters for the product to be tightened might
not yet be available in the torque module's memory. If the
product is SI-AT-compatible, you can scan the QR code
of the corresponding product in the SI-AT-A22 operating in-
structions. In this way you can write the operating parameters
into the memory of the SI-AT module. The operating parame-
ters for the product can also be uploaded to the torque mod-
ule via USB with the AT Documentation Software. Regu-
larly check for updates to the software installed in the torque
module in order to ensure that the latest parameters are al-
ways applied.
4. Lock the torque module. → page 7
12 English
symbol appears on the display
2124681
*2124681*