Switching On And Off - Hilti SI­-AT-­A22 Mode D'emploi Original

5 Operation
5.1 Inserting the adaptive torque module
WARNING
Risk of short circuit !
▶ Before inserting the torque module, make sure that the contacts on the
torque module and the contacts on the impact wrench are free of foreign
matter.
WARNING
Risk of injury by a falling torque module !
▶ Check that the torque module is secure on the impact wrench.
▶ Push the torque module on to the impact wrench from the rear until it
engages with an audible click.
5.2 Inserting the battery
WARNING
Risk of short circuit !
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the torque module are free of foreign matter.
WARNING
Risk of injury by a falling battery !
▶ Check that the battery is secure on the torque module.
▶ Push the battery on to the torque module from the rear until it engages
with an audible click.

5.3 Switching on and off

5.3.1 Switching on the torque module
Conditions: The torque module is switched off, the display is blank.
1. Set the forward/reverse switch on the impact wrench to the "forward"
position.
2. Short-press the control switch on the impact wrench.
▶ The display lights up and briefly shows the
▶ As a function check the LEDs briefly show red and yellow, before
turning green. An acoustic signal sounds.
▶ The last operating mode selected appears inside a selection frame
on the display.
▶ If the display shows a fault:
▶ Refer to the "Troubleshooting"" section for information about
possible causes of error messages and the steps to be taken to
rectify the problem.
6 English
4
2124681
3
start screen.
*2124681*