Setting The Operating Mode - Hilti SI­-AT-­A22 Mode D'emploi Original

▶ Tighten the fastener with the new stage setting and repeat this test
step.
Result 2 / 3
The specified tightening torque of the fastener to be tightened was
exceeded.
▶ Back off the fastener and set the torque module to a lower stage.
▶ Tighten the fastener with the new stage setting and repeat this test
step.
Result 3 / 3
The fastener was tightened to the specified tightening torque.
This stage setting is correct for this fastener.
5.6.3 "Unregulated" operating mode
In this operating mode the adaptive torque module is deactivated. The
impact wrench works as though the adaptive torque module were not fitted
to the tool. The adaptive torque module therefore does not have to be
actually removed when it is not needed for short periods of use.
In the "Unregulated" operating mode the display shows the following:
In "Unregulated" mode the impact
wrench's "AT" torque indicator
does not light up, but the button
on the impact wrench for selecting
the various stages is operational.

5.7 Setting the operating mode

There are 2 ways of setting the operating mode to suit the type of fastener:
• Scan the barcode or QR code on the packaging of the Hilti product you
are going to tighten.
• Manual adjustment using the buttons on the torque module
Scanning the barcode or QR code
If a barcode or a QR code is available for the Hilti product to be tightened,
the operating mode can be set correctly for the product quickly and easily
by scanning the code.
▶ Set the operating mode by scanning the barcode or QR code. → page 12
Manual adjustment
If no barcode or QR code is available for the product to be tightened, the
operating mode can be set by using the buttons on the torque module.
The "Unregulated" operating mode can be set only manually.
▶ Select the operating mode with the control panel buttons. → page 12
*2124681*
2124681 English 11