What To Do In Case Of A Problem - AIRLUX ATIB64BK Notice D'utilisation

WHAT TO DO IN CASE OF A PROBLEM

When the symbol [ E 4 ] appears:
I) The table must be reconfigured. Please implement the following steps:
Important: before you start:
• make sure there is no more pot on the hob
• take a pot with a ferromagnetic bottom and a minimum diameter of 16 cm
• disconnect the appliance from the grid by removing the fuse or turning the circuit breaker off
• start the procedure within 2 minutes after reconnecting the hob to the grid
• reconnect the table to the grid
• don't use the [ 0/I ] touch
II) First step: cancel the existing configuration
1) Press [ - ] and hold down
2) With your other hand, press successively
and quickly (less than 2s) on each [ O ] key.
Begin from the front right side and turn
contrary clockwise, as described on the
picture (from a to d).
A double "beep" means an error occurred. If so, start again from item 1).
3) Remove your fingers from the touch control, press simultaneously [ + ] and [ - ]
during few seconds, until blinking [ E ] symbols appear.
4) Wait until [ E ] symbols stop blinking.
5) After few seconds, [ E ] are automatically transformed in [ C ]. The existing setup
has been cancelled.
Note: For induction hobs with 3 cooking zones, The rear right zone (b) doesn't
exist, so push 2 times on the front right zone (a) that means (a → a → c → d).
III) Second step: new setup
1) Take a ferromagnetical pot with a minimum diameter of 16 cm
2) Select a cooking zone by pushing on the corresponding [ O ] key
3) Place the pot on the area to be set
4) Wait until the [ C ] display becomes a [ - ]. The selected zone is now configured.
5) Follow the same procedure for each cooking zone with a [ C ] display.
6) All the cooking zones are configured once all the displays are turned off.
Please use the same pot for the whole procedure.
Never put several pots together on the zones during the setup-process.
• If [ E 4 ] displaying remains, please call the customer care
The hob or the cooking zone doesn't start-up:
• The hob is badly connected on the electrical network.
• The protection fuse cut-off.
• The locking function is activated.
• The sensitive keys are covered with grease or water.
• An object is put on a key.
The control panel displays [ U ]:
• There is no pan on the cooking zone.
• The pan is not compatible with induction.
• The bottom diameter of the pan is too small.
The control panel displays or [ E ]:
• Disconnect and replug the hob.
• Call the After-sales Service.
d
48
c b
a