Terrier TS Mode D'emploi page 9

7a DISASSEMBLING/ASSEMBLING TS, TS-R, STS, TSE, TSE-R, TSHP CLAMP MODELS
- Open the clamp to its full extent.
- Remove the tension spring (9); in the case of 0,75 TS, 1TS(E), 1,5 TS , 2 & 3 TSE first
remove the retaining pin in the cam assembly (10).
- Remove the retaining pin (10) and the campin (7).
- Push the lifting shackle (5) in until the shackle pin (6) can be removed via the mounting
hole.
- Remove the lifting shackle (5) and the cam assembly (2).
- Dismantle the lever (4) by removing the retaining pin (10) and take the lock assembly (3)
out of the clamp.
- Remove the pivot (8) using a socket and ring spanner.
- Clean all parts with a standard degreasant.
- Grease all shackle pins with a bearing grease.
- Oil the spring if necessary.
- Assemble all the parts in reverse order.
- Always insert new original retaining pins (10) and do so with the aid of a hammer,
combination pliers and pin punch.
- Always fit a new pivot bolt (11) and nut (12).
- When replacing parts always use original Terrier components.
- Remove any burr with a file.
5
6
2
1
Detail : A
16
3
Detail : A
11
8
12
9
10
4
13
10
7
7b DISASSEMBLING/ASSEMBLING TSMP, STSMP, TSEMP CLAMP MODELS
- Open the clamp to its full extent.
- Remove the tension spring (9); in the case of the 0,75 TSMP, 1TS(E)MP, 1,5TSMP, 2 & 3
TSEMP first remove the retaining pin (10) in the cam assembly.
- Remove the retaining pin (10) and the cam pin (7).
- Remove the retaining pin (10) and the link pin (14).
- Remove the lifting shackle (5).
- Push the fork (15) in until the shackle pin can be removed via the mounting hole (6).
- Remove the fork (15) and the cam assembly (2).
- Disassemble the lever (4) by removing the retaining pin (10) and take the lock assembly
(3) out of the clamp.
- Remove the pivot (8) using a socket and ring spanner.
- Clean all parts with a standard
degreasant.
- Grease all shackle pins with bearing grease.
- Oil the spring if necessary.
- Assemble all the parts in reverse order.
- Always insert new original retaining pins (10) and do so with the aid of a hammer,
combination pliers and pin punch.
- Always fit a new pivot bolt (11) and nut (12).
- When replacing parts always use original Terrier components.
- Remove any burr with a file.
Detail : A
8
12
6
2
1
Detail : A
11
5
14
10
15
3
9
10
4
10
17