Bus Drive Via As Interface; Power Off - Burkert TopControl ON/OFF 8631 Instructions De Service

3.5.3 Bus drive via AS interface

Programming data:
I/O configuration
ID code
Data bit
Signal
Value 0
Value 1
Status display:
LED1
(yellow)
off
off
on
flashing
off
26
DD hex (1 output, 3 inputs)
F hex (see below for assignment)
D3 D2
Input Input
initiator 1 initiator 2
Position Position
not reached not reached
Position Position
reached reached
LED2 Status signalled
(red)
off

POWER OFF

on No data traffic
(expired watchdog at slave address not 0)
off ok
on Slave address 0
flashing Overload of sensor supply
D1 D0
Input Output
diagnosis control valve
coil current
ok Control valve
off
Error (inter- Control valve
ruption) on
Top Control ON/OFF