Troubleshooting - RedMax BHT250PD60 Manuel D'utilisation

Maintenance
Make sure that the battery is charged.
Make sure that the battery charger is not damaged.
Make sure that the screws that hold the cutter blades together are correctly tight-
ened.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
To examine the battery and the battery
charger
1. Examine the battery for damages, for example
cracks.
2. Examine the battery charger for damages, for
example cracks.
3. Make sure that the battery charger connection wire
is intact and that there are no cracks in it.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
To examine the cutter blade
1. Clean the cutter blades from unwanted materials
with an anti corrosion cleaning agent before and
after you use the product.
Keypad
LED display
Green activate LED flashing
Red error LED flashing
12

Troubleshooting

Possible faults
Low battery voltage.
Overload.
Temperature deviation.
The power trigger and the acti-
vate button are pressed at the
same time.
2. Examine the edges of the cutter blade for damages
and deformation.
3. Use a file to remove burrs on the cutter blade.
4. Make sure that the cutter blades move freely.
To lubricate the cutter blade
1. Lubricate the cutter blade bars with a recommended
spray grease before long periods of storage.
Gearbox
The gearbox is maintenace free during normal
operation. Add grease to the gear if the gearbox has
been disassembled or repaired. Talk to your dealer for
information and supply of gearbox grease. A small
amount of a special high quality grease shall be used.
Do not fill the gearbox to its maximum with grease.
Possible action
Charge the battery.
The cutting attachment is jammed. deacti-
vate the product. Remove the battery. Clean
the cutting attachment from unwanted mate-
rials.
Let the product cool down.
Release the power trigger and the product is
active.
Before
Weekly Monthly
use
X
X
X
437 - 002 - 02.01.2018
X