Operating the device
7
Operating the device
7.1
Switching the extractor hood on and off
➤ Press the
button to switch the extractor hood on or off.
7.2
Setting the time
I
NOTE
•
When the extractor hood is connected to the power supply, the
display shows 00:00.
•
After three seconds without any entries, the settings are saved.
➤ Switch off the extractor hood.
➤ Press the
button for about four seconds to set the hours.
✓ A confirmation signal is emitted.
✓ All the digits on the clock flash.
➤ Set the hours with the buttons
➤ Press the
button once briefly to set the minutes.
✓ A confirmation signal is emitted.
✓ All the digits on the clock flash.
➤ Set the minutes with the buttons
➤ Wait three seconds.
✓ The digits on the clock light up permanently.
✓ The new time setting is saved.
I
NOTE
In the time between 8 pm and 6 am, the display on the clock disappears
after 5 minutes if none of the buttons have been pressed.
7.3
Switching the light on and off
➤ Press the
button to switch the light on and off.
16
or
.
or
.
CK500
EN