Installing And Connecting The Extractor Hood - Dometic CK Série Instructions De Montage Et De Service

CK500
6.3

Installing and connecting the extractor hood

➤ Push the air outlet hose (fig. 7 1, page 5) on the air outlet adapter into the
extractor hood (fig. 7 2, page 5).
➤ Fix the air outlet hose onto the air outlet adapter with a cable binder.
➤ Remove the filter.
➤ Lift the extractor hood into the required position and guide the air outlet hose
and the connection cable through the hole in the wall-mounted cupboard.
➤ Secure the extractor hood with four screws (fig. 8, page 6).
To do this, use screws with the following size:
– Diameter 4 mm
– Length according to the thickness of the wall-mounted cupboard
➤ Replace the filter.
➤ Connect the connection cable to the DC power supply.
Make sure the polarity is correct.
6.4 Completing the air outlet guide
➤ Lubricate and clean the area around the roof opening.
➤ Apply the upper part of the mushroom vent with a permanently elastic sealing
material (e.g. Dekalin) (fig. 9, page 6).
➤ Place the upper part of the mushroom vent into the roof opening.
➤ Push the air outlet hose onto the lower part of the mushroom vent (fig. 0,
page 7).
➤ Fix the air outlet hose onto the lower part of the mushroom vent with a cable
binder.
➤ Push the lower part of the mushroom vent into upper part (fig. a, page 7) from
the inside.
➤ Secure the lower part of the mushroom vent with three screws.
To do this, use screws with the following size:
– Diameter 4 mm
– Length = roof thickness – 10 mm
➤ Fix the air outlet hose with the adhesive socket (fig. 4 1, page 4) and cable
binders at suitable places.
EN
Installing the device
15