Quick HECTOR HC3 Série Manuel De L'utilisateur page 14

MAINTENANCE
GB
61
7
2
3
4
5
8 6
56
41
40
55
57
59
GYPSY SIDE
Using the handle (22) remove the bush (2) loosen the screws (21), remove the gypsy cover (20) and the top clutch cone (19); loosen
the fixing screws (30) of the rope/chain stripper (29) and remove it (leave the pin, spring and handle in place). Pull off the gypsy (18).
DRUM SIDE
With the handle (22) release the bush (2) and pull off the drum (3).
Clean all the parts removed to avoid corrosion and grease (with marine grease) the shaft thread (14, 15 or 16) and the gypsy (18)
where the clutch cones rest (17 and 19).
14
9
10
11
12
13
14
6
53
49
48
46
45
52
47
44
43
42
Quick
vironments. In any case, any salt deposits on the outside must be removed
60
periodically to avoid corrosion and damage to the equipment.
The parts where salt may have built up should be washed thoroughly with
fresh water.
58
Once a year, the drum and the gypsy are to be taken apart as follows:
13
12
13
16
15
10
9 1
54
26
35
50
34
51
27
36
37
38
39
WARNING: make sure the electrical power to the motor is switched off
when working manually on the windlass. Carefully remove the chain or
rope from the gypsy or the rope from the drum.
windlasses are manufactured with materials resistant to marine en-
®
23
24
25
17
18
19
20
21
29
2
32
28
31
30
33
HECTOR 700/1000/1500W - REV008A
3
22