Vortice Punto M 90 Notice D'emploi Et D'entretien page 12

D. Vortice Punto Pull Cord NORMAL / AUTOMATIC
This model is equipped with a pull-cord for
switching it on and off manually.
E. Vortice Punto T HCS NORMAL / AUTOMATIC
The appliance features a relative humidity sensor that
is factory set at 60%. When relative humidity exceeds
that level, the appliance automatically starts up. This
threshold setting can however be modified by the
installer to 4 levels: 60%, 70%, 80% and 90% (fig. 14).
The circuit is also equipped with a timer that can be
set at between 3 and 20 minutes by adjusting the
trimmer (see fig. 14). The unit switches on
automatically a few seconds after the light is
switched on and continues to run for the preset
period of time after the light is switched off.
S
T
NORMAL
A
N
D
A
AUTOMATIC
R
D
L
O
NORMAL
N
G
L
I
AUTOMATIC
F
E
This is the complete range of Vortice Punto Models. Not all versions are available in all countries.
12
A
DIAMETER STANDARD MODEL
∅ 090
•
∅ 100
•
∅ 120
•
∅ 150
•
∅ 100
•
∅ 120
•
∅ 150
•
A
DIAMETER STANDARD MODEL
∅ 100
•
∅ 120
•
∅ 150
•
∅ 100
•
∅ 120
•
∅ 150
•
G. Vortice Punto 12 VOLT
NORMAL / AUTOMATIC
IMPORTANT: USE EXCLUSIVELY WITH A
VORTICE 12V POWER SUPPLY UNIT
This model features Class III construction, i.e.
electrical safety is based on the use of a safety low
voltage power supply - a condition that is
guaranteed only when the product is used in
conjunction with VORTICE GA 12V - 12V T - 12V P
- 12V MHC - 12V HCS power supply units.
B C D
TIMER PIR PULL CORD
•
• • •
• • •
• • •
• • •
• • •
• • •
B C
TIMER PIR
• •
• •
• •
• •
• •
• •
E G
T HCS 12 V
• •
• –
• –
• •
• –
• –
D E
PULL CORD T HCS
• •
• •
• •
• •
• •
• •
F
MHC
•
•
•
•
•
•