Control Elements; Control Panel (If Included In Supply); Command Unit (Front Face) (Rear Face) - Ten Haaft Command Unit Mode D'emploi Abrégé

SHORT USER MANUAL COMMAND UNIT

3. CONTROL ELEMENTS

3.1 Control panel (if included in supply)

You may choose any location you like to install the control panel, but please bear in mind that it is not waterproof. You may still
need to remove the protective film from the display.
The display of the control panel will show the various operating modes of the system. We recommend you to install the control
panel in a location where the display is clearly visible.
The display is illuminated, so it is not a problem if it is installed in a very dark location.
To ensure safe and reliable operation of the system, please make sure the external unit is in rest mode before disconnecting the
control panel. Check that no text is shown in the display – this is an indication that the system is in rest mode.
Without control panel, the system is controlled by the Oyster® TV connected to it. You can also control the system using your
mobile device or tablet with the free ten Haaft® app.
16
On / Off
Menu command "forward"
Menu command "back"
Menu command "OK"
SHORT USER MANUAL COMMAND UNIT
3. CONTROL ELEMENTS

3.2 Command Unit (front face) (rear face)

The Command Unit controls either the functions of the external unit via a hard-wired control panel, via the app or via the
Oyster® TV.
Control panel
1. USB USB port (for updates via USB stick)
2. Power button This button switches the entire antenna system on and off. If you press
this button while the antenna is in motion, it will stop immediately (emer-
gency stop).
When the antenna is open and stopped, pressing this key will cause the
system to retract (park) and shut down (standby).
3. „Star" button
reserved
4. „i" button This button has various functions that are indicated by the colour of the LED.
Antenna
Control1
SAT
Ant.
10 A
31 30 15
Battery
Inputs/outputs
1. antenna control 4-pin plug contracable external unit
2. Powersuply Ignition/ terminal 15/ D+ and 12V/ 24V powersupply
3. Fuse 10 A (FKS-Mini, red)
4. Ant SAT IN from external unit (Antenna)
5. TV set SAT OUT to Receiver/ TV
6. Mode Rotary switch for SAT mode (default setting 0 = automatic mode)
7. CI-Bus Optional control input
8. CTRL Control panel (if included in supply)
9. WiFi WiFi antenna
TV
CI
Bus
17