Control Elements; Vision Control Center (Front Face) (Rear Face); Warning Tone Vision Control Center - Ten Haaft VISION CONTROL CENTER Mode D'emploi Abrégé

SHORT USER MANUAL VISION CONTROL CENTER

3. CONTROL ELEMENTS

3.1 Control panel (if included in supply)
Attention: If the control panel is not included in the scope of delivery:
only the V5 control panel is compatible with the Vision Control Center!
You may choose any location you like to install the control panel, but please bear in mind that it is not water-
proof. You may still need to remove the protective film from the display.
The display of the control panel will show the various operating modes of the system. We recommend you to
install the control panel in a location where the display is clearly visible.
The display is illuminated, so it is not a problem if it is installed in a very dark location.
To ensure safe and reliable operation of the system, please make sure the external unit is in rest mode before
disconnecting the control panel. Check that no text is shown in the display – this is an indication that the system
is in rest mode.
Without control panel, the system is controlled by the Oyster® TV connected to it. You can also control the
system using your mobile device or tablet with the free ten Haaft® app.

3.2 Vision Control Center (front face) (rear face)

The Vision Control Center controls either the functions of the external unit via a hard-wired control panel, via
the app or via the Oyster® TV.
Das Vision Control Center
22
On / Off
Menu command "forward"
Menu command "back"
Menu command "OK"
SHORT USER MANUAL VISION CONTROL CENTER
Control panel
1. USB USB port (for updates via USB stick)
2. Power button This button switches the entire antenna system on and off. If you press
this button while the antenna is in motion, it will stop immediately
(emergency stop).
When the antenna is open and stopped, pressing this key will cause the
system to retract (park) and shut down (standby).
3. „Star" button reserved
4. „i" button This button has various functions that are indicated by the colour of the
LED.
Antenna
Control1
SAT
Ant.
10 A
31 30 15
Battery
Inputs/outputs
1. Antenna control 14-pin plug contracable external unit
2. Powersuply Ignition/ terminal 15/ D+ and 12V/ 24V powersupply
3. Fuse 10 A (FKS-Mini, red)
4. Ant SAT IN from external unit (Antenna)
5. TV set SAT OUT to Receiver/ TV
6. Mode Rotary switch for SAT mode (default setting 0 = automatic mode)
7. CI-Bus Optional control input
8. CTRL Control panel (if included in supply)
9. WLAN WLAN antenna

3.3 Warning Tone Vision Control Center

The Vision Control Center will sound a warning tone if the vehicle engine is started before the antenna is fully
retracted and in its 'Park' position.
If the vehicle engine is started whilst the antenna is still open, the antenna will automatically retract. This can
take up to 40 seconds. A short signal tone will indicate that the antenna must retract fully before the vehicle
can be moved.
If the antenna, for whatever reason, cannot be fully retracted, a constant warning tone will be heard. This
warning tone will only stop once the antenna is either fully retracted or the vehicles ignition (Terminal
15) is turned off.
TV
CI
Bus
23