Montage; Power Supply; Connections - Ten Haaft Command Unit Mode D'emploi Abrégé

SHORT USER MANUAL COMMAND UNIT
2.

MONTAGE

2.2 Connections

3
4
5
9
10
11
Battery
Antenna Control
17 18
only with TWIN
(optional)
14
Direction of travel
1
2
6
8
7
13
12
14
Separate
power
supply
SHORT USER MANUAL COMMAND UNIT
2. MONTAGE
Connections at the Command unit
Number Explanation
1
Antenna unit
2
Mounting plate
3
Elbow fitting / roof feed-through
4
Satellite harness from exterior unit (black hose)
5
Command Unit
6
Control panel (if included in supply)
7
Coaxial cable to receiver
8
Receiver / TV with integrated receiver
Connect here the antenna plug (F plug) of the provided control cable to the external unit.
9
(Control cable and coax cable to the external unit are together in a black sheath.)
10
Fuse
Separate
Connect the power-supply cable provided here.
power
supply
CAUTION!
Ensure that the other end of the power-supply cable is correctly connected to the onboard
electric system. If polarity is reversed, the FeatureBox may be destroyed!
11
Onboard system terminal 15: Ignition / D+ (optional, see 2.1) (black)
Onboard system terminal 30: Onboard system voltage 12/24V DC (red)
Onboard system terminal 31: Vehicle ground / chassis (brown)
12
Connecting cable (brown – battery negative)
15
13
Connecting cable (red – battery positive)
14
Body battery Coaxial cable to receiver
16
15
Connecting cable (black – safety circuit)
16
Ignition-switched terminal 15 of vehicle
17
optional TWIN cable
18
2. TV set only with TWIN-LNB
15