Maytag MGR8800FZ1 Instructions D'installation page 15

3. Remove plastic cover from gas pressure regulator cap.
4. Turn gas pressure regulator cap counterclockwise with a 5/8"
(1.6 cm) combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
A
B
C
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
5. Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
" LP" is facing the direction shown in the above drawing
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to Propane
Gas)
1. Remove burner cap.
2. Using a Phillips or Quadrex
base.
NOTE: Reinstall one of the screws through the range
cooktop to hold the orifice spud holder in place while
removing and replacing the orifice spuds.
A
B
A. Igniter electrode
B. Gas tube opening
Side view before
D
E
Side view after
screwdriver, remove the burner
®
C
D
C. Burner cap
D. Burner base
3. Apply masking tape to the end of a 9/32" (7 mm) nut driver
to help hold the gas orifice spud in the nut driver while
changing it. Press nut driver down onto the gas orifice spud
and remove by turning it counterclockwise and lifting out.
Set gas orifice spud aside.
A
B
A. Orifice spud
B. Orifice spud holder
4. Remove the cardboard orifice spud holder shipped in the
literature package in the oven. Gas orifice spuds are
stamped with a number, marked with 1 color dot, and have a
groove in the hex area. Replace the Natural gas orifice spud
with the correct Propane gas orifice spud.
A. Propane groove
Refer to the following chart for correct Propane gas orifice
spud placement.
Propane Gas Orifice Spud Chart for Surface Burner
Placement Burner
Rating/Type
LF 14,200 BTU
LR 8,000 BTU
RF 14,200 BTU
RR 5,000 BTU
CTR 8,000 BTU
NOTE: Refer to the Model/Serial/rating Plate located on the oven
frame behind the top left side of the oven door for proper sizing
of spuds for each burner location.
5. Place Natural gas orifice spuds in the cardboard orifice spud
holder.
6. Replace the burner base using both screw.
7. Replace burner cap.
8. Repeat steps 1 through 7 for the remaining burners.
C
D
C. Screw
D. Spark electrode
A
Size (mm) ID Number
1.08 108AM
0.84 084AM
1.08 108AM
0.64 064AM
0.84 084AM
15