Program Mode - General Rules For Navigation In The Software; Basic Navigation - Hedson IRT 3-1 PcD Mode D'emploi

7. Program Mode – General rules for navigation in the software
– The display shows software defined options in the bottom corner fields.
To adjust the values use the arrow keys.
–
– To move to previous display without saving, press cancel.
7.1

Basic navigation

There are twelve predefined programs and three empty ones. All 15 programs have editable positions, names and
drying parameters.
Scroll up or down using the arrow keys, press select to run the program or view to edit.
7.2
7.2.1 Distance check
The distance is indicated on the display
as "too close", "too far" or "correct". If
measuring fails "check distance manu-
Stop or cancel
ally" appears.
returns to 7.1.
Use the cassette button to alter be-
tween one or two active cassettes.
7.2.2 Start drying
Press start to begin the drying
sequence. The remaining time of the
"flash off" will start counting down.
When the "flash off" is finished, the
program automatically changes to full
bake mode.
7.2.3 Program values
Press view and the screen shows the
values for power (0–100 % of machine
capacity) and energy consumption of
current drying process.
7.2.4 Energy consumption
Total energy consumption per drying
process is shown for the last 10 runs.
7.2.5 Drying complete
When flash off and full bake times have
expired the software returns to 7.1.
Note! To extend the lifetime of the
lamps, the ventilators will continue to
run for cooling. After three minutes
they turn off automatically.
713686 rev 8
1. Putty 6. Topcoat
2. Filler Bright 7. Clearcoat
3. Filler Dark 8. Plast Filler
4. Waterbase 9. Plast Topcoat
5. Basecoat 10. Plast Clearcoat
Run
11. Final boost
12. Soft cure
13. Free prog
14. Free prog
15. Free prog
7.3
7.3.1 Properties
The values of the chosen program will
show on the display.
Stop or cancel
7.3.2 PIN Code
returns to 7.1.
Use the arrow keys to set the correct
digit. Press enter to confirm and to edit
the second, third and fourth digit of the
advanced PIN code.
Note! An entered PIN code is valid for all
entries until the main switch is turned off.
Use arrow keys
See chapter 8.2 for "advanced PIN code".
to set numbers.
7.3.3 Edit program parameters
When marked, change the value of the
parameters with the arrow keys. Press
enter to change the next value and so
on. Pressing enter for the last value
directs the user to editing of program
position and name. Press cancel to exit
without saving any parameters.
The program
returns to 7.3.1.
7.3.4 Edit program position/
When marked, change the program
number with the arrow keys. Press enter
to confirm and to edit the next symbol.
Note! Changing the number will also
change the program position in the
The program
program list.
returns to 7.3.1.
7.3.5 Expansion of the program
When the drying process requires more
than the two standard steps, you can ex-
pand the number of steps in the drying
cycle by linking to the next program.
Start from point 7.3.4 and press Enter
The program
repeatedly until the Link to next pro-
returns to 7.3.1.
gram appears on the screen. Select with
the arrow keys Yes or No, and then press
Save. The link to the next program will
remain until it is deactivated (No). Use
the program 13, 14 or 15 as these are
free programs without any default.
EN
Edit
name
steps
5 5