Control Panel Glass; Cooktop Light Replacement; Oven Light - Whirlpool WLP83810 Guide D'utilisation Et D'entretien

BROILER PAN AND GRID
Do not clean in the Self-Cleaning cycle.
Mildly abrasive cleanser:
Scrub with wet scouring pad.
Solution of ¹ ₂ cup (125 mL) ammonia to 1 gal. (3.75 L) water:
Soak for 20 minutes, then scrub with scouring or steel wool
pad.
Oven cleaner:
Follow product label instructions.
Porcelain enamel only, not chrome
Dishwasher
STORAGE DRAWER ( on some models)
Make sure drawer is cool and empty before cleaning.
For more information, see "Storage Drawer" section.
Mild detergent
Drawer Liner (on some models)
Remove all stored items from drawer and lift out drawer liner.
Clean with mild detergent.
WARMING DRAWER and TRAY ( on some models)
Make sure drawer is cool and remove tray.
Mild detergent (for both)

Control Panel Glass

(on some models)
The control panel glass can be removed for easier cleaning. Do
not clean the electronics behind the glass because damage can
occur.
To Remove:
1. Remove control knobs by pulling straight out.
2. Release clips.
3. Remove glass by pulling slightly up and forward.
20

Cooktop Light Replacement

(on models with fluorescent light)
To Replace the Fluorescent Light Tube:
1. Unplug range or disconnect power.
2. Flip up the top of the backguard.
3. Grasp both ends of the fluorescent tube.
4. Turn the tube 90° in either direction until both ends come out
of the receptacles.
5. Replace tube, replace top of the control panel.
6. Plug in range or reconnect power.

Oven Light

(on some models)
The oven light is a standard 40-watt appliance bulb. It will come
on when the oven door is open. It will not work during the Self-
Cleaning cycle. On some models, when the oven door is closed,
press OVEN LIGHT to turn it on or off.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are off.
To replace:
1. Unplug range or disconnect power.
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb and bulb cover by turning clockwise.
5. Plug in range or reconnect power.