Troubelshooting - Ayce J1X-SM01A-216 Traduction De La Notice Originale

TROUBELSHOOTING

Fault Possible cause
Motor does Motor, cable or plug defective,
not work fuses burnt
The motor Voltage too low, coils damaged,
starts up capacitor burnt
slowly
and does
not reach
operating
speed.
Motor makes Coils damaged, motor
excessive defective
noise
The motor Circuits in the network are
does not overloaded (lamps, other
reach its full motors, etc.)
power.
Motor Overloading of the motor,
overheats insufficient cooling of the
easily. motor
Reduced Saw blade too small (ground
cutting power too much)
when sawing
Saw cut is Saw blade dull, tooth shape
rough or wavy not appropriate for the
material thickness
Workpiece Excessive cutting pressure
pulls away and/or saw blade not suitable
and/or for use
splinters
128 | 129
Remedy
Arrange for inspection of the
machine by a specialist, never
repair the motor yourself, Danger!
check fuses and replace as
necessary
Contact the utility provider to
check the voltage, arrange for
inspection of the motor by a
specialist, arrange for replacement
of the capacitor by a specialist
Arrange for inspection of the
motor by a specialist
Do not use any other equipment or
motors on the same circuit
Avoid overloading the motor while
cutting, remove dust from the
motor in order to ensure optimal
cooling of the motor
Readjust end stop of the saw unit
Resharpen saw blade and/or use
suitable saw blade
Insert suitable saw blade
GB